Error Performance Measurement in Packet-switched Networks
draft-mirsky-ippm-epm-00
| Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
|
|
|---|---|---|---|
| Authors | Greg Mirsky , Xiao Min | ||
| Last updated | 2021-01-14 (Latest revision 2020-07-13) | ||
| Replaced by | draft-mhmcsfh-ippm-pam | ||
| RFC stream | (None) | ||
| Formats | |||
| Additional resources | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes the use of the error performance metric to characterize a packet-switched network's conformance to the pre- defined set of performance objectives. In this document, metrics that characterize error performance in a PSN are defined, as well as methods to measure and calculate them. Also, the requirements for an active OAM protocol to support EPM in PSN are discussed, and potential candidate protocols analyzed. All metrics and measurement methods are equally applicable to underlay and overlay networks.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)