BFD in Demand Mode over Point-to-Point MPLS LSP
draft-mirsky-bfd-mpls-demand-02
The information below is for an old version of the document.
Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Active".
Expired & archived
|
|
---|---|---|---|
Author | Greg Mirsky | ||
Last updated | 2018-04-26 (Latest revision 2017-10-23) | ||
RFC stream | (None) | ||
Formats | |||
Additional resources | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes procedures for using Bidirectional Forwarding Detection (BFD) in Demand mode to detect data plane failures in Multiprotocol Label Switching (MPLS) point-to-point Label Switched Paths.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)