Marking Converter for Excess-Marked Traffic
draft-menth-pcn-marking-converter-00
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Michael Menth , Frank Lehrieder | ||
Last updated | 2008-07-07 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document proposes an algorithm that converts packet markings of a stream that was excess-marked based on a lower-rate into packet markings that correspond to a stream that was excess-marked based on a higher-rate. It may be applied in the PCN context to convert marked admissible-rate-overload into marked supportable-rate- overload. This allows to perform marked flow termination when packets are excess-marked based on the admissible rate only.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)