Skip to main content

L2TP Circuit Emulation Services Extension
draft-mcpherson-l2tp-es-01

Document Type Expired Internet-Draft (individual)
Expired & archived
Authors Danny R. McPherson , Ravi Bail Bhat , Andy Koscinski , Chi Fai Ho
Last updated 2000-06-02
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

The Layer 2 Tunneling Protocol (L2TP) [RFC2661] defines a mechanism for tunneling PPP sessions. This document proposes mechanisms by which the L2TP tunneling scheme can be used to provide circuit emulation support for layer 2 circuits (i.e. Frame Relay or ATM), as well as TDM circuits (i.e. DS1 or DS3). L2TP is used to provide tunneling support and each circuit is encapsulated over a session inside the Tunnel. An Encapsulation Services Protocol [RefESP] is used on top of the individual L2TP sessions to support the circuit emulation of layer 2 VCs or TDM circuits. The purpose of this document is to explain the L2TP modifications done to facilitate support of circuit emulation services, as well as to define the additional AVPs that can be used to provide the service.

Authors

Danny R. McPherson
Ravi Bail Bhat
Andy Koscinski
Chi Fai Ho

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)