Building Automation Routing Requirements in Low Power and Lossy Networks
draft-martocci-roll-building-routing-reqs-01
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Jerry Martocci , Nicolas Riou , Pieter Mil , Wouter Vermeylen | ||
Last updated | 2009-12-14 (Latest revision 2008-10-14) | ||
Replaced by | draft-ietf-roll-building-routing-reqs | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-roll-building-routing-reqs | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The Routing Over Low power and Lossy network (ROLL) Working Group has been chartered to work on routing solutions for Low Power and Lossy networks (LLN) in various markets: Industrial, Commercial (Building), Home and Urban. Pursuant to this effort, this document defines the routing requirements for building automation. Requirements Language The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC-2119.
Authors
Jerry Martocci
Nicolas Riou
Pieter Mil
Wouter Vermeylen
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)