Pseudowire Status for Static Pseudowires
draft-martini-pwe3-static-pw-status-02
Document | Type | Replaced Internet-Draft (individual) | |
---|---|---|---|
Last updated | 2010-04-20 (latest revision 2009-10-24) | ||
Replaced by | draft-ietf-pwe3-static-pw-status | ||
Stream | (None) | ||
Intended RFC status | (None) | ||
Formats |
Expired & archived
pdf
htmlized
bibtex
|
||
Stream | Stream state | (No stream defined) | |
Consensus Boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-pwe3-static-pw-status | |
Telechat date | |||
Responsible AD | (None) | ||
Send notices to | (None) |
https://www.ietf.org/archive/id/draft-martini-pwe3-static-pw-status-02.txt
Abstract
This document specifies a mechanism to signal Pseudowire (PW) status messages using an PW associated channel (ACh). Such a mechanism is suitable for use where no PW dynamic control plane exits, known as static PWs, or where a Terminating Provider Edge (T-PE) needs to send a PW status message directly to a far end T-PE. The mechanism allows PW OAM message mapping and PW redundancy to operate on static PWs.
Authors
Luca Martini
(lmartini@cisco.com)
George Swallow
(swallow@cisco.com)
Matthew Bocci
(matthew.bocci@alcatel-lucent.co.uk)
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)