Requirements for Very Fast Setup of GMPLS LSPs
draft-malis-ccamp-fast-lsps-04

Document Type Replaced Internet-Draft (individual)
Last updated 2014-11-20
Replaced by RFC 7709
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-teas-fast-lsps-requirements
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-malis-ccamp-fast-lsps-04.txt

Abstract

Establishment and control of Label Switch Paths (LSPs) have become mainstream tools of commercial and government network providers. One of the elements of further evolving such networks is scaling their performance in terms of LSP bandwidth and traffic loads, LSP intensity (e.g., rate of LSP creation, deletion, and modification), LSP set up delay, quality of service differentiation, and different levels of resilience. The goal of this document is to present target scaling objectives and the related protocol requirements for Generalized Multi-Protocol Label Switching (GMPLS).

Authors

Andrew Malis (agmalis@gmail.com)
Ronald Skoog (rskoog@appcomsci.com)
Haim Kobrinski (hkobrinski@appcomsci.com)
George Clapp (clapp@research.att.com)
Vishnu Shukla (vishnu.shukla@verizon.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)