MPLS Capability set
draft-loa-mpls-cap-set-01

Document Type Expired Internet-Draft (mpls WG)
Last updated 1999-10-26
Stream IETF
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream WG state WG Document
Document shepherd No shepherd assigned
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-loa-mpls-cap-set-01.txt

Abstract

Several protocols might be used for Label Distribution in an MPLS network, e.g. Label Distribution Protocol (LDP), including the part of LDP described in Constraint-Based LSP Setup using LDP, the BGP-4 and RSVP. The functionality defined in those protocols are to some extent overlapping, but also complementary. This document specifies a number of MPLS Capability sets that can be used to define what is needed from an MPLS implementation in order to interwork with other implementations. The number of Capability sets might change in the future.

Authors

Loa Andersson (loa@pi.se)
Tom Worster (tom.worster@gdc.com)
Bilel Jamoussi (jamoussi@nortel.ca)
Muckai Girish (mgirish@tri.sbc.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)