Processing Multiple Replies for One Request in NETCONF
draft-liu-netconf-multiple-replies-01
| Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Expired".
Expired & archived
|
|
|---|---|---|---|
| Authors | Bing Liu , Guangying Zheng , Mahesh Jethanandani , Kent Watsen | ||
| Last updated | 2016-01-07 (Latest revision 2015-07-06) | ||
| RFC stream | (None) | ||
| Formats | |||
| Additional resources | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document discusses several scenarios that multiple replies for a single request are needed, with the ability to terminate the replies at any time. Such scenarios are not well supported by current NETCONF (Network Configuration) protocol. An extention at the NETCONF messaging layer is needed to fulfill the requirement.
Authors
Bing Liu
Guangying Zheng
Mahesh Jethanandani
Kent Watsen
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)