The Layer Refresh Request (LRR) RTCP Feedback Message
draft-lennox-avtext-lrr-00
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Jonathan Lennox , Danny Hong , Justin Uberti , Stefan Holmer , Magnus Flodman | ||
| Last updated | 2015-03-09 | ||
| Replaced by | draft-ietf-avtext-lrr | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-avtext-lrr | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This memo describes the RTP Payload-Specific Feedback Message "Layer Refresh Request" (LRR), which can be used to request a state refresh of one or more substreams of a layered media stream. It also defines its use with several scalable media formats.
Authors
Jonathan Lennox
Danny Hong
Justin Uberti
Stefan Holmer
Magnus Flodman
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)