An Upgrade to Benchmarking Methodology for Network Interconnect Devices
draft-lencse-bmwg-rfc2544-bis-00

Document Type Expired Internet-Draft (individual)
Authors Gábor Lencse  , Keiichi Shima 
Last updated 2020-11-21 (latest revision 2020-05-20)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-lencse-bmwg-rfc2544-bis-00.txt

Abstract

RFC 2544 has defined a benchmarking methodology for network interconnect devices. We recommend a few upgrades to it for producing more reasonable results. The recommended upgrades can be classified into two categories: the application of the novelties of RFC 8219 for the legacy RFC 2544 use cases and the following new ones. Checking a reasonably small timeout individually for every single frame in the throughput and frame loss rate benchmarking procedures. Performing a statistically relevant number of tests for all benchmarking procedures. Addition of an optional non-zero frame loss acceptance criterion for the throughput measurement procedure and defining its reporting format.

Authors

Gábor Lencse (lencse@hit.bme.hu)
Keiichi Shima (keiichi@iijlab.net)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)