Avoiding Loops in MPLS
draft-leecy-mpls-loop-avoidance-01
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Dr. Yoshihiro Ohba , Loa Andersson , Cheng-Yin Lee | ||
Last updated | 1999-11-11 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document proposes a general method to avoid loops while setting up Label Switched Paths (LSPs), and is applicable to both unicast and multicast label setup. The approach taken is to solve the problem of constructing a tree for delivering data. The solution verifies the path towards the root of the tree is loop free before a node is grafted to the tree. This loop avoidance scheme complements loop detection in LDP.
Authors
Dr. Yoshihiro Ohba
Loa Andersson
Cheng-Yin Lee
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)