Skip to main content

Accurate ECN Feedback Option in TCP
draft-kuehlewind-tcpm-accurate-ecn-option-00

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Expired".
Expired & archived
Authors Mirja Kühlewind , Richard Scheffenegger
Last updated 2012-04-26 (Latest revision 2011-10-24)
RFC stream (None)
Formats
Additional resources
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document specifies an TCP option to get accurate Explicit Congestion Notification (ECN) feedback from the receiver. ECN is an IP/TCP mechanism where network nodes can mark IP packets instead of dropping them to indicate congestion to the end-points. An ECN- capable receiver will feedback this information to the sender. ECN is specified for TCP in such a way that only one feedback signal can be transmitted per Round-Trip Time (RTT). Recently new TCP mechanisms like ConEx or DCTCP need more accurate feedback information in the case where more than one marking is received in one RTT. This TCP extension can be used in addition to the classic ECN as well as with a more accurate ECN scheme recently proposed which reuses the ECN bit in the TCP header.

Authors

Mirja Kühlewind
Richard Scheffenegger

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)