Skip to main content

Bulk DHCPv4 Lease Query
draft-kinnear-dhc-dhcpv4-bulk-leasequery-01

Document Type Replaced Internet-Draft (individual)
Expired & archived
Authors Kim Kinnear , Bernie Volz , Neil Russell , Mark Stapp , D.T.V. Ramakrishna Rao , Bharat Joshi , Pavan Kurapati
Last updated 2009-03-11 (Latest revision 2008-11-03)
Replaced by draft-ietf-dhc-dhcpv4-bulk-leasequery
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-dhc-dhcpv4-bulk-leasequery
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

The Dynamic Host Configuration Protocol for IPv4 (DHCPv4) has been extended with a Leasequery capability that allows a requestor to request information about DHCPv4 bindings. That mechanism is limited to queries for individual bindings. In some situations individual binding queries may not be efficient, or even possible. This document expands on the DHCPv4 Leasequery protocol to allow for bulk transfer of DHCPv4 address binding data via TCP.

Authors

Kim Kinnear
Bernie Volz
Neil Russell
Mark Stapp
D.T.V. Ramakrishna Rao
Bharat Joshi
Pavan Kurapati

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)