Skip to main content

Advertising L2 Bundle Member Link Attributes in OSPF
draft-ketant-lsr-ospf-l2bundles-00

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
Authors Ketan Talaulikar , Peter Psenak
Last updated 2020-01-05 (Latest revision 2019-07-04)
Replaced by draft-ietf-lsr-ospf-l2bundles, draft-ietf-lsr-ospf-l2bundles, RFC 9356
RFC stream (None)
Formats
Additional resources
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

There are deployments where the Layer 3 interface on which OSPF operates is a Layer 2 interface bundle. Existing OSPF advertisements only support advertising link attributes of the Layer 3 interface. If entities external to OSPF wish to control traffic flows on the individual physical links which comprise the Layer 2 interface bundle link attribute information about the bundle members is required. This document introduces the ability for OSPF to advertise the link attributes of layer 2 (L2) Bundle members.

Authors

Ketan Talaulikar
Peter Psenak

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)