RADIUS Attribute for MAP
draft-jiang-softwire-map-radius-04

Document Type Replaced Internet-Draft (candidate for softwire WG)
Authors Sheng Jiang  , Yu Fu  , Bing Liu  , Peter Deacon 
Last updated 2013-10-28 (latest revision 2013-04-26)
Replaced by RFC 8658, RFC 8658
Stream Internet Engineering Task Force (IETF)
Formats
Expired & archived
pdf htmlized bibtex
Additional Resources
- Mailing list discussion
Stream WG state Call For Adoption By WG Issued
Document shepherd No shepherd assigned
IESG IESG state Replaced by draft-ietf-softwire-map-radius, draft-ietf-softwire-map-radius
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-jiang-softwire-map-radius-04.txt

Abstract

Mapping of Address and Port (MAP) is a stateless mechanism for running IPv4 over IPv6-only infrastructure. It provides both IPv4 and IPv6 connectivity services simultaneously during the IPv4/IPv6 co- existing period. The Dynamic Host Configuration Protocol for IPv6 (DHCPv6) MAP options has been defined to configure MAP Customer Edge (CE). However, in many networks, the configuration information may be stored in Authentication Authorization and Accounting (AAA) servers while user configuration is mainly from Broadband Network Gateway (BNG) through DHCPv6 protocol. This document defines a Remote Authentication Dial In User Service (RADIUS) attribute that carries MAP configuration information from AAA server to BNG. The MAP RADIUS attribute are designed following the simplify principle. It provides just enough information to form the correspondent DHCPv6 MAP option.

Authors

Sheng Jiang (jiangsheng@huawei.com)
Yu Fu (eleven.fuyu@huawei.com)
Bing Liu (leo.liubing@huawei.com)
Peter Deacon (peterd@iea-software.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)