Unified IPv4-in-IPv6 Softwire CPE
draft-ietf-softwire-unified-cpe-01

The information below is for an old version of the document
Document Type Expired Internet-Draft (softwire WG)
Last updated 2013-12-01 (latest revision 2013-05-30)
Replaces draft-bfmk-softwire-unified-cpe
Stream IETF
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Reviews
Additional URLs
- Mailing list discussion
Stream WG state WG Document
Document shepherd No shepherd assigned
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-ietf-softwire-unified-cpe-01.txt

Abstract

Transporting IPv4 packets encapsulated in IPv6 is a common solution to the problem of IPv4 service continuity over IPv6-only provider networks. A number of differing functional approaches have been developed for this, each having their own specific characteristics. As these approaches share a similar functional architecture and use the same data plane mechanisms, this memo describes a specification whereby a single CPE can interwork with all of the standardized and proposed approaches to providing encapsulated IPv4 in IPv6 services.

Authors

Mohamed Boucadair (mohamed.boucadair@orange.com)
Ian Farrer (ian.farrer@telekom.de)
Simon Perreault (simon.perreault@viagenie.ca)
Senthil Sivakumar (ssenthil@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)