ICMP and IGMP for the Simple Internet Protocol Plus (SIPP)

Document Type Expired Internet-Draft (sipp WG)
Last updated 1994-03-14
Stream IETF
Intended RFC status (None)
Expired & archived
pdf htmlized bibtex
Stream WG state WG Document
Document shepherd No shepherd assigned
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


The Simple Internet Protocol Plus (SIPP) is a new version of IP. SIPP uses the Internet Control Message Protocol (ICMP) and the Internet Group Management Protocol (IGMP) with a few changes. This document describes the format of control messages used in ICMP and IGMP for SIPP. This document does not describe the procedures that use these messages to achieve functions like Router Discovery and Path MTU Discovery; these procedures are described in companion documents. Terminology defined in the SIPP specification and the SIPP Routing and Addressing specification applies to this document as well.


Steve Deering (deering@cisco.com)
Ramesh Govindan (govindan@isi.edu)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)