Skip to main content

Root initiated routing state in RPL
draft-ietf-roll-dao-projection-04

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Active".
Expired & archived
Authors Pascal Thubert , Rahul Jadhav , James Pylakutty
Last updated 2018-12-21 (Latest revision 2018-06-19)
Replaces draft-thubert-roll-dao-projection
RFC stream Internet Engineering Task Force (IETF)
Formats
Reviews
Additional resources Mailing list discussion
Stream WG state WG Document
Revised I-D Needed - Issue raised by WGLC
Associated WG milestone
May 2022
Initial submission of a root initiated routing state in RPL to the IESG
Document shepherd (None)
IESG IESG state Expired
Consensus boilerplate Unknown
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document proposes a protocol extension to RPL that enables to install a limited amount of centrally-computed routes in a RPL graph, enabling loose source routing down a non-storing mode DODAG, or transversal routes inside the DODAG. As opposed to the classical route injection in RPL that are injected by the end devices, this draft enables the root of the DODAG to projects the routes that are needed on the nodes where they should be installed.

Authors

Pascal Thubert
Rahul Jadhav
James Pylakutty

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)