Pseudowire Setup and Maintenance using the Label Distribution Protocol
draft-ietf-pwe3-rfc4447bis-03
| Document | Type |
Replaced Internet-Draft
(pals WG)
Expired & archived
|
|
|---|---|---|---|
| Authors | Luca Martini , Giles Heron | ||
| Last updated | 2015-03-09 | ||
| Replaced by | draft-ietf-pals-rfc4447bis | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | WG Document | |
| Document shepherd | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-pals-rfc4447bis | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Layer 2 services (such as Frame Relay, Asynchronous Transfer Mode, and Ethernet) can be "emulated" over an MPLS backbone by encapsulating the Layer 2 Protocol Data Units (PDU) and then transmitting them over "pseudowires". It is also possible to use pseudowires to provide low-rate Time Division Multiplexed and Synchronous Optical NETworking circuit emulation over an MPLS-enabled network. This document specifies a protocol for establishing and maintaining the pseudowires, using extensions to the Label Distribution Protocol (LDP). Procedures for encapsulating Layer 2 PDUs are specified in a set of companion documents. This document has been written to address errata in a previous version of this standard.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)