Requirements and Framework for Point-to-Multipoint Pseudowires over MPLS PSNs

The information below is for an old version of the document
Document Type Expired Internet-Draft (pwe3 WG)
Last updated 2012-08-29 (latest revision 2011-09-08)
Replaces draft-jounay-pwe3-p2mp-pw-requirements
Stream IETF
Intended RFC status Informational
Expired & archived
pdf htmlized bibtex
Additional URLs
- Mailing list discussion
Stream WG state WG Document
Revised I-D Needed - Issue raised by AD
Document shepherd Andrew Malis
IESG IESG state Expired (IESG: Dead)
Consensus Boilerplate Unknown
Telechat date
Responsible AD Stewart Bryant
IESG note Andrew Malis ( is the document shepherd.
Send notices to,

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


This document presents a set of requirements and a framework for providing a Point-to-Multipoint Pseudowire (PW). The requirements identified in this document are related to architecture, signaling and maintenance aspects of Point-to-Multipoint PW operation. They are proposed as guidelines for the standardization of such mechanisms. Among other potential applications Point-to-Multipoint PWs SHOULD be used to optimize the support of multicast layer 2 services (Virtual Private LAN Service and Virtual Private Multicast Service) as defined in the Layer 2 Virtual Private Network Working Group.


Matthew Bocci (
Giles Heron (
Yuji Kamite (

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)