MPLS and Ethernet OAM Interworking
draft-ietf-pwe3-mpls-eth-oam-iwk-04
| The information below is for an old version of the document | |||
|---|---|---|---|
| Document | Type | Expired Internet-Draft (pwe3 WG) | |
| Last updated | 2011-03-02 (latest revision 2010-07-12) | ||
| Replaces | draft-mohan-pwe3-mpls-eth-oam-iwk | ||
| Stream | IETF | ||
| Intended RFC status | (None) | ||
| Formats |
Expired & archived
pdf
htmlized (tools)
htmlized
bibtex
|
||
| Reviews | |||
| Stream | WG state | Waiting for WG Chair Go-Ahead | |
| Document shepherd | Matthew Bocci | ||
| IESG | IESG state | Expired | |
| Consensus Boilerplate | Unknown | ||
| Telechat date | |||
| Responsible AD | (None) | ||
| Send notices to | (None) | ||
https://www.ietf.org/archive/id/draft-ietf-pwe3-mpls-eth-oam-iwk-04.txt
Abstract
This document specifies the mapping of defect states between Ethernet Attachment Circuits (ACs) and associated Ethernet Pseudowires (PWs) connected in accordance to the PWE3 architecture [RFC3985] to realize an end-to-end emulated Ethernet service. This document augments the mapping of defect states between a PW and associated AC of the end-to-end emulated service in [PW-OAM-MSG- MAP]. In [PW-OAM-MSG-MAP], Ethernet OAM was not covered due to lack of Ethernet OAM maturity. However, since then, [Y.1731] and [802.1ag] have been completed, and this document specifies the mapping of defect states between Ethernet ACs and corresponding Ethernet PWs.
Authors
Dinesh Mohan
(dinmohan@hotmail.com)
Nabil Bitar
(nabil.n.bitar@verizon.com)
Philippe Niger
(philippe.niger@francetelecom.com)
Ray Qiu
(rayq@huawei.com)
Simon DeLord
(simon.a.delord@team.telstra.com)
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)