Skip to main content

PW Endpoint Fast Failure Protection
draft-ietf-pwe3-endpoint-fast-protection-02

Document Type Replaced Internet-Draft (pals WG)
Expired & archived
Authors Yimin Shen , Rahul Aggarwal , Wim Henderickx , Yuanlong Jiang
Last updated 2015-01-21
Replaces draft-shen-pwe3-endpoint-fast-protection
Replaced by draft-ietf-pals-endpoint-fast-protection
RFC stream Internet Engineering Task Force (IETF)
Intended RFC status Proposed Standard
Formats
Additional resources Mailing list discussion
Stream WG state WG Document
Revised I-D Needed - Issue raised by WGLC
Document shepherd Matthew Bocci
IESG IESG state Replaced by draft-ietf-pals-endpoint-fast-protection
Consensus boilerplate Unknown
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document specifies a fast mechanism for protecting pseudowires against egress endpoint failures, including egress attachment circuit failure, egress PE failure, multi-segment PW terminating PE failure, and multi-segment PW switching PE failure. Designed on the basis of multi-homed CE, PW redundancy, upstream label assignment and context specific label switching, the mechanism enables local repair to be performed by the router upstream adjacent to a failure. In particular, the router can restore PW traffic in the order of tens of milliseconds, by transmitting the traffic to a protector through a pre-established bypass tunnel. Therefore, the mechanism can reduce traffic loss before global repair reacts to the failure and the network converges on the topology changes due to the failure.

Authors

Yimin Shen
Rahul Aggarwal
Wim Henderickx
Yuanlong Jiang

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)