Skip to main content

PPP Over Asynchronous Transfer Mode Adaptation Layer 2 (AAL2)
draft-ietf-pppext-ppp-over-aal2-03

The information below is for an old version of the document that is already published as an RFC.
Document Type
This is an older version of an Internet-Draft that was ultimately published as RFC 3336.
Authors bruce Buffam , Thima Koren , Bruce Thompson
Last updated 2013-03-02 (Latest revision 2002-03-04)
RFC stream Internet Engineering Task Force (IETF)
Intended RFC status Proposed Standard
Formats
Additional resources Mailing list discussion
Stream WG state (None)
Document shepherd (None)
IESG IESG state Became RFC 3336 (Proposed Standard)
Action Holders
(None)
Consensus boilerplate Unknown
Telechat date (None)
Responsible AD Dr. Thomas Narten
IESG note ** No value found for 'doc.notedoc.note' **
Send notices to <karlfox@columbus.rr.com>
draft-ietf-pppext-ppp-over-aal2-03
A new Request for Comments is now available in online RFC libraries.

        RFC 3336
                                    
        Title:      PPP Over Asynchronous Transfer Mode Adaptation
                    Layer 2
        Author(s):  B. Thompson, T. Koren, B. Buffam
        Status:     Standards Track
        Date:       December 2002
        Mailbox:    brucet@cisco.com, tmima@cisco.com,
                    bruce@seawaynetworks.com
        Pages:      16
        Characters: 33631
        Updates/Obsoletes/SeeAlso:    None
                                    
        I-D Tag:    draft-ietf-pppext-ppp-over-aal2-03.txt

        URL:        ftp://ftp.rfc-editor.org/in-notes/rfc3336.txt

The Point-to-Point Protocol (PPP) provides a standard method for
transporting multi-protocol datagrams over point-to-point links.

This document describes the use of ATM Adaptation Layer 2 (AAL2) for
framing PPP encapsulated packets.

This document is a product of the Point-to-Point Protocol Extensions
Working Group of the IETF.

This is now a Proposed Standard Protocol.

This document specifies an Internet standards track protocol for
the Internet community, and requests discussion and suggestions
for improvements.  Please refer to the current edition of the
"Internet Official Protocol Standards" (STD 1) for the
standardization state and status of this protocol.  Distribution
of this memo is unlimited.

This announcement is sent to the IETF list and the RFC-DIST list.
Requests to be added to or deleted from the IETF distribution list
should be sent to IETF-REQUEST@IETF.ORG.  Requests to be
added to or deleted from the RFC-DIST distribution list should
be sent to RFC-DIST-REQUEST@RFC-EDITOR.ORG.

Details on obtaining RFCs via FTP or EMAIL may be obtained by sending
an EMAIL message to rfc-info@RFC-EDITOR.ORG with the message body 
help: ways_to_get_rfcs.  For example:

        To: rfc-info@RFC-EDITOR.ORG
        Subject: getting rfcs

        help: ways_to_get_rfcs

Requests for special distribution should be addressed to either the
author of the RFC in question, or to RFC-Manager@RFC-EDITOR.ORG.  Unless
specifically noted otherwise on the RFC itself, all RFCs are for
unlimited distribution.echo 
Submissions for Requests for Comments should be sent to
RFC-EDITOR@RFC-EDITOR.ORG.  Please consult RFC 2223, Instructions to RFC
Authors, for further information.