How to Write an RTP Payload Format
draft-ietf-payload-rtp-howto-01

The information below is for an old version of the document
Document Type Expired Internet-Draft (payload WG)
Last updated 2011-07-11 (latest revision 2011-03-03)
Replaces draft-ietf-avt-rtp-howto
Stream IETF
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Reviews
Stream WG state WG Document
Document shepherd Ali Begen
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-ietf-payload-rtp-howto-01.txt

Abstract

This document contains information on how to best write an RTP payload format. It provides reading tips, design practices, and practical tips on how to produce an RTP payload format specification quickly and with good results. A template is also included with instructions that can be used when writing an RTP payload format.

Authors

Magnus Westerlund (magnus.westerlund@ericsson.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)