RTP Payload Format for High Efficiency Video Coding
draft-ietf-payload-rtp-h265-02

The information below is for an old version of the document
Document Type None Internet-Draft (payload WG)
Last updated 2014-02-12
Stream IETF
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Reviews
Additional URLs
- Mailing list discussion
Stream WG state (None)
Document shepherd None
IESG IESG state Unknown state
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-ietf-payload-rtp-h265-02.txt

Abstract

This memo describes an RTP payload format for the video coding standard ITU-T Recommendation H.265 and ISO/IEC International Standard 23008-2, both also known as High Efficiency Video Coding (HEVC) [HEVC], developed by the Joint Collaborative Team on Video Coding (JCT-VC). The RTP payload format allows for packetization of one or more Network Abstraction Layer (NAL) units in each RTP packet payload, as well as fragmentation of a NAL unit into multiple RTP packets. Furthermore, it supports transmission of an HEVC stream over a single as well as multiple RTP flows. The payload format has wide applicability in videoconferencing, Internet video streaming, and high bit-rate entertainment-quality video, among others.

Authors

Ye-Kui Wang (yekuiw@qti.qualcomm.com)
Yago Sanchez (yago.sanchez@hhi.fraunhofer.de)
Thomas Schierl (ts@thomas-schierl.de)
Stephan Wenger (stewe@stewe.org)
Miska Hannuksela (miska.hannuksela@nokia.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)