Sub-interface VLAN YANG Data Models
draft-ietf-netmod-sub-intf-vlan-model-05

The information below is for an old version of the document
Document Type Expired Internet-Draft (netmod WG)
Last updated 2019-09-07 (latest revision 2019-03-06)
Replaces draft-wilton-netmod-intf-vlan-yang
Stream IETF
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Additional URLs
- Mailing list discussion
Stream WG state In WG Last Call
Document shepherd Lou Berger
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to Lou Berger <lberger@labn.net>

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-ietf-netmod-sub-intf-vlan-model-05.txt

Abstract

This document defines YANG modules to add support for classifying traffic received on interfaces as Ethernet/VLAN framed packets to sub-interfaces based on the fields available in the Ethernet/VLAN frame headers. These modules allow configuration of Layer 3 and Layer 2 sub-interfaces (e.g. attachment circuits) that can interoperate with IETF based forwarding protocols; such as IP and L3VPN services; or L2VPN services like VPWS, VPLS, and EVPN. The sub-interfaces also interoperate with VLAN tagged traffic orginating from an IEEE 802.1Q compliant bridge. The model differs from an IEEE 802.1Q bridge model in that the configuration is interface/sub-interface based as opposed to being based on membership of an 802.1Q VLAN bridge. The YANG data models in this document conforms to the Network Management Datastore Architecture (NMDA) defined in RFC 8342.

Authors

Robert Wilton (rwilton@cisco.com)
David Ball (daviball@cisco.com)
tapsingh@cisco.com (tapsingh@cisco.com)
Selvakumar Sivaraj (ssivaraj@juniper.net)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)