LDP Extensions for RMR
draft-ietf-mpls-ldp-rmr-extensions-01
| Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Expired".
Expired & archived
|
|
|---|---|---|---|
| Authors | Santosh Esale , Kireeti Kompella | ||
| Last updated | 2019-05-08 (Latest revision 2018-11-04) | ||
| Replaces | draft-esale-mpls-ldp-rmr-extensions | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Formats | |||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | WG Document | |
| Document shepherd | Loa Andersson | ||
| IESG | IESG state | Expired | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | Loa Andersson <loa@pi.nu> |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes LDP extensions to signal Resilient MPLS Ring (RMR) Label Switched Paths (LSPs). An RMR LSP is a multipoint to point LSP signaled using LDP (Label Distribution Protocol). RMR Architecture document - draft-ietf-mpls-rmr-02 - describes why and how MPLS should be used in ring topologies.
Authors
Santosh Esale
Kireeti Kompella
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)