Skip to main content

A YANG Data Model for LMAP Measurement Agents
draft-ietf-lmap-yang-12

Yes

(Alissa Cooper)

No Objection

(Alia Atlas)
(Alvaro Retana)
(Ben Campbell)
(Benoît Claise)
(Deborah Brungard)
(Jari Arkko)
(Joel Jaeggli)
(Stephen Farrell)

Note: This ballot was opened for revision 11 and is now closed.

Alissa Cooper Former IESG member
Yes
Yes (for -11) Unknown

                            
Alexey Melnikov Former IESG member
No Objection
No Objection (2017-03-16 for -11) Unknown
I only skimmed the document, but I have no objections.
Alia Atlas Former IESG member
No Objection
No Objection (for -11) Unknown

                            
Alvaro Retana Former IESG member
No Objection
No Objection (for -11) Unknown

                            
Ben Campbell Former IESG member
No Objection
No Objection (for -11) Unknown

                            
Benoît Claise Former IESG member
(was Discuss, No Objection) No Objection
No Objection (2017-04-21 for -11) Unknown

                            
Deborah Brungard Former IESG member
No Objection
No Objection (for -11) Unknown

                            
Jari Arkko Former IESG member
No Objection
No Objection (for -11) Unknown

                            
Joel Jaeggli Former IESG member
No Objection
No Objection (for -11) Unknown

                            
Kathleen Moriarty Former IESG member
No Objection
No Objection (2017-03-13 for -11) Unknown
The security considerations looks good, but can't YANG also be accessed via RESTCONF?  What considerations are needed for that?  I thunk we went through this for I2RS, do considerations for RESTCONF apply to this YANG module?
Mirja Kühlewind Former IESG member
(was Discuss) No Objection
No Objection (2017-03-21 for -11) Unknown
Thanks for the feedback! Still some comments:

- Maybe make RFC7594 a normative reference.

- It could be good to give some further guidance on how connectivity is established. Something like, in most cases the controller will connect the MA and the controller should make sure that it reconnects frequently based on the timeout configuration of the MA. If the MA e.g. is behind a NAT, the MA must establish the initial connection and try to reconnect when the timeout expires. Btw. is it enough to open a transport connection or do you mean by checking connectivity that there also should be some data transmitted to ensure that the controller is no only reachable but also active?

- I still think there might be further information needed on bootstrapping. This draft only says:
"Pre-Configuration Information: This is not modeled explicitly since bootstrapping information is outside the scope of this data model."
Stephen Farrell Former IESG member
No Objection
No Objection (for -11) Unknown

                            
Suresh Krishnan Former IESG member
No Objection
No Objection (2017-03-15 for -11) Unknown
Figure 1:
  There is a typo (actually four typos) in the yang module name

ietf-lmap-comman.yang should be ietf-lmap-common.yang instead