LISP Virtual Private Networks (VPNs)
draft-ietf-lisp-vpn-12
| Document | Type |
Expired Internet-Draft
(lisp WG)
Expired & archived
|
|
|---|---|---|---|
| Authors | Victor Moreno , Dino Farinacci | ||
| Last updated | 2024-03-22 (Latest revision 2023-09-19) | ||
| Replaces | draft-moreno-lisp-vpn | ||
| RFC stream | Internet Engineering Task Force (IETF) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Additional resources | Mailing list discussion | ||
| Stream | WG state | WG Document | |
| Document shepherd | (None) | ||
| IESG | IESG state | Expired | |
| Consensus boilerplate | Unknown | ||
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes the use of the Locator/ID Separation Protocol (LISP) to create Virtual Private Networks (VPNs). LISP is used to provide segmentation in both the LISP data plane and control plane. These VPNs can be created over the top of the Internet or over private transport networks, and can be implemented by Enterprises or Service Providers. The goal of these VPNs is to leverage the characteristics of LISP - routing scalability, simply expressed Ingress site TE Policy, IP Address Family traversal, and mobility, in ways that provide value to network operators.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)