Simple Two-way Active Measurement Protocol (STAMP) Data Model
draft-ietf-ippm-stamp-yang-06

Document Type Active Internet-Draft (ippm WG)
Authors Greg Mirsky  , Xiao Min  , Wei Luo 
Last updated 2020-10-07
Replaces draft-mirsky-ippm-stamp-yang
Stream IETF
Intended RFC status (None)
Formats plain text xml pdf htmlized (tools) htmlized bibtex
Yang Validation 0 errors, 2 warnings.
Reviews
Additional Resources
- Yang catalog entry for ietf-stamp@2020-10-07.yang
- Yang impact analysis for draft-ietf-ippm-stamp-yang
- Mailing list discussion
Stream WG state WG Document
Document shepherd Tal Mizrahi
IESG IESG state I-D Exists
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to Tal Mizrahi <tal.mizrahi.phd@gmail.com>
Network Working Group                                          G. Mirsky
Internet-Draft                                                    X. Min
Intended status: Standards Track                               ZTE Corp.
Expires: April 10, 2021                                           W. Luo
                                                                Ericsson
                                                         October 7, 2020

     Simple Two-way Active Measurement Protocol (STAMP) Data Model
                     draft-ietf-ippm-stamp-yang-06

Abstract

   This document specifies the data model for implementations of
   Session-Sender and Session-Reflector for Simple Two-way Active
   Measurement Protocol (STAMP) mode using YANG.

Status of This Memo

   This Internet-Draft is submitted in full conformance with the
   provisions of BCP 78 and BCP 79.

   Internet-Drafts are working documents of the Internet Engineering
   Task Force (IETF).  Note that other groups may also distribute
   working documents as Internet-Drafts.  The list of current Internet-
   Drafts is at https://datatracker.ietf.org/drafts/current/.

   Internet-Drafts are draft documents valid for a maximum of six months
   and may be updated, replaced, or obsoleted by other documents at any
   time.  It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as "work in progress."

   This Internet-Draft will expire on April 10, 2021.

Copyright Notice

   Copyright (c) 2020 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (https://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

Mirsky, et al.           Expires April 10, 2021                 [Page 1]
Internet-Draft              STAMP Data Model                October 2020

Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   2
     1.1.  Conventions used in this document . . . . . . . . . . . .   2
       1.1.1.  Requirements Language . . . . . . . . . . . . . . . .   2
   2.  Scope, Model, and Applicability . . . . . . . . . . . . . . .   3
     2.1.  Data Model Parameters . . . . . . . . . . . . . . . . . .   3
       2.1.1.  STAMP-Sender  . . . . . . . . . . . . . . . . . . . .   3
       2.1.2.  STAMP-Reflector . . . . . . . . . . . . . . . . . . .   4
   3.  Data Model  . . . . . . . . . . . . . . . . . . . . . . . . .   4
     3.1.  Tree Diagrams . . . . . . . . . . . . . . . . . . . . . .   4
     3.2.  YANG Module . . . . . . . . . . . . . . . . . . . . . . .  10
   4.  IANA Considerations . . . . . . . . . . . . . . . . . . . . .  31
   5.  Security Considerations . . . . . . . . . . . . . . . . . . .  31
   6.  Acknowledgments . . . . . . . . . . . . . . . . . . . . . . .  32
   7.  References  . . . . . . . . . . . . . . . . . . . . . . . . .  32
     7.1.  Normative References  . . . . . . . . . . . . . . . . . .  32
     7.2.  Informative References  . . . . . . . . . . . . . . . . .  34
   Appendix A.  Example of STAMP Session Configuration . . . . . . .  34
   Authors' Addresses  . . . . . . . . . . . . . . . . . . . . . . .  35

1.  Introduction

   The Simple Two-way Active Measurement Protocol (STAMP) [RFC8762] can
   be used to measure performance parameters of IP networks such as
   latency, jitter, and packet loss by sending test packets and
   monitoring their experience in the network.  The STAMP protocol
   [RFC8762] in unauthenticated mode is on-wire compatible with STAMP
   Light, discussed in Appendix I [RFC5357].  The STAMP Light is known
   to have many implementations though no common management framework
   being defined, thus leaving some aspects of test packet processing to
   interpretation.  As one of the goals of STAMP is to support these
   variations, this document presents their analysis; describes common
   STAMP and STAMP model while allowing for STAMP extensions in the
   future.  This document defines the STAMP data model and specifies it
   formally, using the YANG data modeling language [RFC7950].

   This version of the interfaces data model conforms to the Network
   Management Datastore Architecture (NMDA) defined in [RFC8342].

1.1.  Conventions used in this document

1.1.1.  Requirements Language

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and
   "OPTIONAL" in this document are to be interpreted as described in BCP

Mirsky, et al.           Expires April 10, 2021                 [Page 2]
Show full document text