Using Device-provided Location-Related Measurements in Location Configuration Protocols
draft-ietf-geopriv-held-measurements-05

The information below is for an old version of the document
Document Type Expired Internet-Draft (geopriv WG)
Last updated 2013-01-06 (latest revision 2012-07-05)
Replaces draft-thomson-geopriv-held-measurements
Stream IETF
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Reviews
Additional URLs
- Mailing list discussion
Stream WG state WG Document
Document shepherd None
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-ietf-geopriv-held-measurements-05.txt

Abstract

A method is described by which a Device is able to provide location- related measurement data to a LIS within a request for location information. Location-related measurement information are observations concerning properties related to the position of a Device, which could be data about network attachment or about the physical environment. When a LIS generates location information for a Device, information from the Device can improve the accuracy of the location estimate. A basic set of location-related measurements are defined, including common modes of network attachment as well as assisted Global Navigation Satellite System (GNSS) parameters.

Authors

Martin Thomson (martin.thomson@gmail.com)
James Winterbottom (james.winterbottom@commscope.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)