Using Device-provided Location-Related Measurements in Location Configuration Protocols
draft-ietf-geopriv-held-measurements-04

The information below is for an old version of the document
Document Type Expired Internet-Draft (geopriv WG)
Last updated 2012-04-29 (latest revision 2011-10-27)
Replaces draft-thomson-geopriv-held-measurements
Stream IETF
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Reviews
Stream WG state WG Document
Document shepherd None
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-ietf-geopriv-held-measurements-04.txt

Abstract

A method is described by which a Device is able to provide location- related measurement data to a LIS within a request for location information. Location-related measurement information are observations concerning properties related to the position of a Device, which could be data about network attachment or about the physical environment. When a LIS generates location information for a Device, information from the Device can improve the accuracy of the location estimate. A basic set of location-related measurements are defined, including common modes of network attachment as well as assisted Global Navigation Satellite System (GNSS) parameters.

Authors

Martin Thomson (martin.thomson@commscope.com)
James Winterbottom (james.winterbottom@commscope.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)