Bundle Protocol Security Specification

The information below is for an old version of the document
Document Type Active Internet-Draft (dtn WG)
Authors Edward Birrane  , Kenneth McKeever 
Last updated 2020-10-25 (latest revision 2020-03-10)
Replaces draft-birrane-dtn-sbsp
Stream Internet Engineering Task Force (IETF)
Formats pdf htmlized bibtex
Additional Resources
- Mailing list discussion
Stream WG state Submitted to IESG for Publication (wg milestone: Jul 2019 - Bundle Security Prot... )
Document shepherd Scott Burleigh
Shepherd write-up Show (last changed 2019-06-19)
IESG IESG state IESG Evaluation
Consensus Boilerplate Yes
Telechat date
Has enough positions to pass.
Responsible AD Magnus Westerlund
Send notices to Scott Burleigh <Scott.C.Burleigh@jpl.nasa.gov>
IANA IANA review state Version Changed - Review Needed
IANA expert review state Expert Reviews OK
IANA expert review comments An update on this assignment: we have converged on the registry questions in the new Bundle Protocol specification, agreeing to register new BPv7 block type numbers in the existing Bundle Block Types registry rather than starting up a new registry for BPv7 block types. This means that block type numbers 2 and 3 -- originally requested for the BPsec BIB and BCB blocks -- are not available (they are used by the old Bundle Authentication Block and Payload Integrity Block), so we must assign from one of the unassigned ranges. The BPbis specification requests that block types 11 and 12 be reserved for the Block Integrity Block and Block Confidentiality Block respectively, so those are the values that I would propose we assign. My understanding is that a slightly revised BPsec Internet Draft will be posted that simply requests that IANA assign numbers for these two blocks, without specifically asking for any particular values, so in the end I think there will be no conflict.
Error; cannot read 'draft-ietf-dtn-bpsec-23.txt'