LISP Trans in MPLS Networks
draft-hu-lisp-mpls-trans-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | fangwei hu , Zhongyu Gu , Lizhong Jin | ||
| Last updated | 2010-07-26 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document proposes an LISP trans solution in MPLS network, provides a new LISP data encapsulation with two layer MPLS label and simplifies the IP-in-IP encapsulation by cutting of the outer IP header when LISP technology deploys in the MPLS network, the outer label is used for data forwarding, and the inner label is used to indicate the LISP data packet and carry the RLOC address information. In additional, three deployment scenarios are provided in this document..
Authors
fangwei hu
Zhongyu Gu
Lizhong Jin
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)