Skip to main content

An Information Model for I2RS Reading Information Policy
draft-hares-i2rs-im-read-info-policy-00

Document Type Expired Internet-Draft (individual)
Expired & archived
Authors Susan Hares , Qin Wu
Last updated 2014-08-17 (Latest revision 2014-02-13)
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

The Interface to the routing system (I2RS) specifies a new interface that a client (I2RS client) can utilize to interface to the routing system. Some applications that utilize the services of I2RS client may require a specific set of data in response to network events or conditions based on pre-established rules. In order to reduce the data flow through the network, the I2RS client needs to signal the I2RS agent to filter some of the collected data or events prior to transmission to the i2rs client. This functionality is necessary to meet the requirements I2RS enabled services which include service- layer routing improvements, and control of traffic flows and exit points. This document introduces a read-only I2RS RIB policy Informational Model that provides filters for the reads and notifications from the I2RS RIB Info Model (IM). This model utilizes a generic information model (IM) for policy templates that is extensible and hierarchical. These templates support the features described by the I2RS architectural model.

Authors

Susan Hares
Qin Wu

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)