An Enhanced Source Routing Header Based on RH3
draft-han-6man-enhanced-source-routing-header-02
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Han Jie , Wang Huilai | ||
Last updated | 2021-07-26 (Latest revision 2021-01-18) | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
IPv6 Routing header type 3 (termed as RH3) is defined and used in Low-Power and Lossy Networks (LLNs) that are typically constrained in resources (limited communication data rate, processing power, energy capacity, memory). Based on the mechanisms introduced by RH3, this document specifies an new IPv6 Routing Header type that provides encapsulation capability of segments with various lengths and can be applied to more scenarios.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)