UDP Path for In-band Performance Measurement for Segment Routing Networks
draft-gandhi-spring-udp-pm-02
Document | Type | Replaced Internet-Draft (individual) | |
---|---|---|---|
Last updated | 2018-09-14 | ||
Replaced by | draft-gandhi-spring-rfc6374-srpm-udp | ||
Stream | (None) | ||
Intended RFC status | (None) | ||
Formats |
Expired & archived
pdf
htmlized
bibtex
|
||
Stream | Stream state | (No stream defined) | |
Consensus Boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-gandhi-spring-rfc6374-srpm-udp | |
Telechat date | |||
Responsible AD | (None) | ||
Send notices to | (None) |
https://www.ietf.org/archive/id/draft-gandhi-spring-udp-pm-02.txt
Abstract
Segment Routing (SR) is applicable to both Multiprotocol Label Switching (SR-MPLS) and IPv6 (SRv6) data planes. This document specifies procedures for using UDP path for sending and processing in-band probe query and response messages for Performance Measurement. The procedure uses the RFC 6374 defined mechanisms for Delay and Loss performance measurement. The procedure specified is applicable to SR-MPLS and SRv6 data planes for both links and end-to-end measurement for SR Policies. This document also defines mechanisms for handling Equal Cost Multipaths (ECMPs) for SR Policies. In addition, this document defines Return Path Segment List TLV for two-way performance measurement and Block Number TLV for loss measurement.
Authors
Rakesh Gandhi
(rgandhi@cisco.com)
Clarence Filsfils
(cfilsfil@cisco.com)
Daniel Voyer
(daniel.voyer@bell.ca)
Stefano Salsano
(stefano.salsano@uniroma2.it)
Pier Ventre
(pierluigi.ventre@cnit.it)
Mach Chen
(mach.chen@huawei.com)
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)