Performance Measurement Using TWAMP Light for Segment Routing Networks
draft-gandhi-spring-twamp-srpm-11
Document | Type | Replaced Internet-Draft (spring WG) | |
---|---|---|---|
Authors | Rakesh Gandhi , Clarence Filsfils , Daniel Voyer , Mach Chen , Bart Janssens | ||
Last updated | 2020-12-16 (latest revision 2020-10-21) | ||
Replaced by | draft-gandhi-spring-stamp-srpm | ||
Stream | IETF | ||
Intended RFC status | (None) | ||
Formats |
Expired & archived
pdf
htmlized (tools)
htmlized
bibtex
|
||
Stream | WG state | Waiting for WG Chair Go-Ahead | |
Document shepherd | No shepherd assigned | ||
IESG | IESG state | Replaced by draft-gandhi-spring-stamp-srpm | |
Consensus Boilerplate | Unknown | ||
Telechat date | |||
Responsible AD | (None) | ||
Send notices to | (None) |
https://www.ietf.org/archive/id/draft-gandhi-spring-twamp-srpm-11.txt
Abstract
Segment Routing (SR) leverages the source routing paradigm. SR is applicable to both Multiprotocol Label Switching (SR-MPLS) and IPv6 (SRv6) data planes. This document specifies procedure for sending and processing probe query and response messages for Performance Measurement (PM) in Segment Routing networks. The procedure uses the mechanisms defined in RFC 5357 (Two-Way Active Measurement Protocol (TWAMP) Light) and its extensions for Performance Measurement. The procedure specified is applicable to SR-MPLS and SRv6 data planes and is used for both Links and end-to-end SR Paths including SR Policies.
Authors
Rakesh Gandhi
(rgandhi@cisco.com)
Clarence Filsfils
(cfilsfil@cisco.com)
Daniel Voyer
(daniel.voyer@bell.ca)
Mach Chen
(mach.chen@huawei.com)
Bart Janssens
(bart.janssens@colt.net)
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)