Skip to main content

Performance Measurement Using RFC 6374 with UDP Path for Segment Routing Networks
draft-gandhi-spring-rfc6374-srpm-udp-05

Document Type Replaced Internet-Draft (individual)
Expired & archived
Authors Rakesh Gandhi , Clarence Filsfils , Daniel Voyer , Stefano Salsano , Mach Chen
Last updated 2020-08-06
Replaces draft-gandhi-spring-udp-pm
Replaced by draft-gandhi-spring-stamp-srpm
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-gandhi-spring-stamp-srpm
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

Segment Routing (SR) leverages the source routing paradigm. Segment Routing (SR) is applicable to both Multiprotocol Label Switching (SR- MPLS) and IPv6 (SRv6) data planes. This document specifies procedures for using UDP path for sending and processing probe query and response messages for Performance Measurement (PM). The procedure uses the mechanisms defined in RFC 6374 for Performance Delay and Loss Measurement. The procedure specified is applicable to SR-MPLS and SRv6 data planes for both Links and end-to-end SR Paths including SR Policies measurements.

Authors

Rakesh Gandhi
Clarence Filsfils
Daniel Voyer
Stefano Salsano
Mach Chen

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)