Skip to main content

Framework for Multi Stages Multiplexing Configuration in G.709 Optical Transport Network
draft-fuxh-ccamp-multi-stage-multiplex-config-fwk-01

Document Type Expired Internet-Draft (individual)
Expired & archived
Authors Xihua Fu , Malcolm Betts , Ruiquan Jing , Xiaoli Huo , Yunbin Xu
Last updated 2010-07-12
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

Interworking between regions with 1.25G TS and 2.5G TS has been considered in G.709. Multi stages multiplexing would be desirable to facilitate the introduction of new ODU0 and ODUflex signals to an existing network without having to upgrade every node in the network. So ODU0/ODUflex can be mapped into ODU1/ODU2/ODU3 and transit across the 2.5G TS region. Multi stages multiplexing are also used to support the multi-domain OTN applications based on carrier-Carrier, regional-national core interconnection or network tunnels design. This document describes the framework for multi stages multiplexing configuration in G.709 Optical Transport Network.

Authors

Xihua Fu
Malcolm Betts
Ruiquan Jing
Xiaoli Huo
Yunbin Xu

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)