LISP Alternative Topology (LISP+ALT)
draft-fuller-lisp-alt-05
| Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Dino Farinacci , Vince Fuller , David Meyer , Darrel Lewis | ||
| Last updated | 2010-04-08 (Latest revision 2009-02-24) | ||
| Replaced by | draft-ietf-lisp-alt | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Replaced by draft-ietf-lisp-alt | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a method of building an alternative, logical topology for managing Endpoint Identifier to Routing Locator mappings using the Locator/ID Separation Protocol. The logical network is built as an overlay on the public Internet using existing technologies and tools, specifically the Border Gateway Protocol and the Generic Routing Encapsulation. An important design goal for LISP+ALT is to allow for the relatively easy deployment of an efficient mapping system while minimizing changes to existing hardware and software.
Authors
Dino Farinacci
Vince Fuller
David Meyer
Darrel Lewis
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)