LISP Alternative Topology (LISP+ALT)
draft-fuller-lisp-alt-05

Document Type Replaced Internet-Draft (individual)
Last updated 2010-04-08 (latest revision 2009-02-24)
Replaced by draft-ietf-lisp-alt
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-lisp-alt
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-fuller-lisp-alt-05.txt

Abstract

This document describes a method of building an alternative, logical topology for managing Endpoint Identifier to Routing Locator mappings using the Locator/ID Separation Protocol. The logical network is built as an overlay on the public Internet using existing technologies and tools, specifically the Border Gateway Protocol and the Generic Routing Encapsulation. An important design goal for LISP+ALT is to allow for the relatively easy deployment of an efficient mapping system while minimizing changes to existing hardware and software.

Authors

Dino Farinacci (dino@cisco.com)
Vince Fuller (vaf@cisco.com)
David Meyer (dmm@cisco.com)
Darrel Lewis (darlewis@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)