A Framework for Point-to-Multipoint MPLS in Transport Networks
draft-fbb-mpls-tp-p2mp-framework-06
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Dan Frost , Stewart Bryant , Matthew Bocci , Lou Berger | ||
Last updated | 2013-02-21 (Latest revision 2013-01-03) | ||
Replaced by | draft-ietf-mpls-tp-p2mp-framework | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-mpls-tp-p2mp-framework | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The Multiprotocol Label Switching (MPLS) Transport Profile (MPLS-TP) is the common set of MPLS protocol functions defined to enable the construction and operation of packet transport networks. The MPLS-TP supports both point-to-point and point-to-multipoint transport paths. This document defines the elements and functions of the MPLS-TP architecture applicable specifically to supporting point-to- multipoint transport paths. This document is a product of a joint Internet Engineering Task Force (IETF) / International Telecommunication Union Telecommunication Standardization Sector (ITU-T) effort to include an MPLS Transport Profile within the IETF MPLS and PWE3 architectures to support the capabilities and functionalities of a packet transport network.
Authors
Dan Frost
Stewart Bryant
Matthew Bocci
Lou Berger
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)