MPLS Generic Associated Channel (G-ACh) Advertisement Protocol
draft-fbb-mpls-gach-adv-01
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Matthew Bocci , Dan Frost , Stewart Bryant | ||
Last updated | 2012-02-08 (Latest revision 2011-11-30) | ||
Replaced by | draft-ietf-mpls-gach-adv | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-mpls-gach-adv | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The MPLS Generic Associated Channel (G-ACh) provides an auxiliary logical data channel associated with a Label Switched Path (LSP), a pseudowire, or a section (link) over which a variety of protocols may flow. These protocols are commonly used to provide Operations, Administration, and Maintenance (OAM) mechanisms associated with the primary data channel. This document specifies simple procedures by which an endpoint of an LSP, pseudowire, or section may inform the other endpoints of its capabilities and configuration parameters, or other application-specific information. This information may then be used by the receiver to validate or adjust its local configuration, and by the network operator for diagnostic purposes.
Authors
Matthew Bocci
Dan Frost
Stewart Bryant
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)