The UDP Tunnel Transport mode
draft-fairhurst-6man-tsvwg-udptt-03
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Gorry Fairhurst | ||
Last updated | 2010-02-10 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document proposes a standards track protocol called the UDP Tunnel Transport. This protocol updates the UDP processing of RFC 2460 for IPv6 hosts and routers. The update enables a sender to generate a UDP datagram where the UDP checksum is replaced by a header check determined only by the protocol header information. For this use, the document also updates the way the IPv6 UDP length field is interpreted. This mode is intended to minimise the processing cost for the transport of tunnel packets using UDP.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)