Using DHCPv6 for DNS Configuration in Hosts
draft-droms-dnsconfig-dhcpv6-01

Document Type Expired Internet-Draft (individual)
Last updated 2002-03-07
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-droms-dnsconfig-dhcpv6-01.txt

Abstract

An IPv6 device can configure its addresses and locate neighboring routers through stateless address autoconfiguration (RFC2462) and router discovery (RFC2461). Most IPv6 devices will require information about DNS services to make use of the basic IPv6 connectivity.

Authors

Ralph Droms (rdroms@cisco.com)
Thomas Narten (narten@us.ibm.com)
Bernard Aboba (Bernard_Aboba@hotmail.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)