A Guide to Implementing Stateless DHCPv6 Service
draft-droms-dhcpv6-stateless-guide-01
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Author | Ralph Droms | ||
| Last updated | 2002-10-25 | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Stateless DHCPv6 service is used by hosts to obtain configuration information such as the addresses of DNS servers that does not require the maintenance of any dynamic state for individual clients. A host that uses stateless DHCP must have obtained its IPv6 addresses through some other mechanism, typically stateless address autoconfiguration. This document is a guide to the protocol messages and options that must be implemented to provide stateless DHCPv6 service.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)