PCEP Extensions for MPLS-TE LSP Automatic Bandwidth Adjustment with stateful PCE
draft-dhody-pce-stateful-pce-auto-bandwidth-03

The information below is for an old version of the document
Document Type Expired Internet-Draft (individual)
Last updated 2014-07-25 (latest revision 2014-01-21)
Replaced by RFC 8733, RFC 8733
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Additional Resources
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-dhody-pce-stateful-pce-auto-bandwidth-03.txt

Abstract

The Path Computation Element Communication Protocol (PCEP) provides mechanisms for Path Computation Elements (PCEs) to perform path computations in response to Path Computation Clients (PCCs) requests. The extensions described in [STATEFUL-PCE] provide stateful control of Multiprotocol Label Switching (MPLS) Traffic Engineering Label Switched Paths (TE LSP) via PCEP, for a model where the PCC delegates control over one or more locally configured LSPs to the PCE. This document describes the automatic bandwidth adjustment of such LSPs under the Active Stateful PCE model.

Authors

Dhruv Dhody (dhruv.ietf@gmail.com)
Udayasree Palle (udayasree.palle@huawei.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)