PCEP Procedures and Protocol Extensions for Using PCE as a Central Controller (PCECC) for SRv6
draft-dhody-pce-pcep-extension-pce-controller-srv6-06
Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
|
|
---|---|---|---|
Authors | Zhenbin Li , Shuping Peng , Xuesong Geng , Mahendra Singh Negi | ||
Last updated | 2021-08-25 (Latest revision 2021-02-21) | ||
Replaced by | draft-ietf-pce-pcep-extension-pce-controller-srv6 | ||
RFC stream | (None) | ||
Formats | |||
Additional resources | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The Path Computation Element (PCE) is a core component of Software- Defined Networking (SDN) systems. It can compute optimal paths for traffic across a network and can also update the paths to reflect changes in the network or traffic demands. PCE was developed to derive paths for MPLS Label Switched Paths (LSPs), which are supplied to the head end of the LSP using the Path Computation Element Communication Protocol (PCEP). But SDN has a broader applicability than signaled (G)MPLS traffic-engineered (TE) networks, and the PCE may be used to determine paths in a range of use cases. PCEP has been proposed as a control protocol for use in these environments to allow the PCE to be fully enabled as a central controller. A PCE-based Central Controller (PCECC) can simplify the processing of a distributed control plane by blending it with elements of SDN and without necessarily completely replacing it. This document specifies the procedures and PCEP protocol extensions when a PCE-based controller is also responsible for configuring the forwarding actions on the routers for Segment Routing (SR) in IPv6 (SRv6), in addition to computing the SRv6 paths for packet flows and telling the edge routers what instructions to attach to packets as they enter the network.
Authors
Zhenbin Li
Shuping Peng
Xuesong Geng
Mahendra Singh Negi
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)